Evaluation Protocol
Quality assurance testing for high-reliability circuit boards requires destructive cross-sectional microsectioning at specified quality conformance test coupons. An ipc-6012 class 3 microsection provides verified physical evidence of internal plating thickness, hole wall integrity, and dielectric spacing for mission-critical electronics. This evaluation governs vertical interconnect structures, barrel copper thickness, and blind via fill quality after thermal stress testing.
The protocol applies strictly to bare board fabrication coupons and stops before component assembly or reflow processing.
Barrel Analysis
Metallographic preparation requires mounting the coupon in epoxy resin, followed by precision grinding and polishing to expose the center of target plated through-holes. Microscopic examination under high magnification reveals structural anomalies such as etchback defects, foil cracks, and inner layer separations. Plating thickness measurements across the hole wall must meet or exceed minimum Class 3 requirements, which typically demand an average copper thickness of twenty-five micrometers.
An ipc-6012 class 3 microsection exposes thermal stress impacts, such as resin recession or barrel lifting, caused by simulated wave soldering or reflow conditions. Microsection analysts measure active copper thickness across at least three distinct vertical locations along the hole wall. Etch quality at the internal land interface determines whether inner layer interconnections maintain structural integrity under high thermal loads.
Fabricators record microsection photographs to substantiate certificate of compliance documentation for aerospace and medical applications.
Acceptance Limit
Acceptance criteria demand zero internal foil cracks, complete via hole wall coverage, and minimal resin recession after thermal shock testing. Failure observed in an ipc-6012 class 3 microsection results in immediate lot rejection and root-cause analysis of the plating line. Acceptance depends entirely on structural compliance rather than visual surface appearance.