Production Method
Assembly techniques that utilize a reflow oven to solder pinned components eliminate the need for a separate wave soldering or manual soldering step. In through-hole reflow, solder paste is printed directly over the plated holes before the pins are inserted. The entire board then passes through a standard convection oven, where the paste melts and wicks into the barrel of the hole to form a complete joint.
Process Requirement
Success with through-hole reflow requires precise control over the volume of solder paste deposited, as the paste must provide enough metal to fill the entire hole and form a fillet on both sides. Special stencils with overprinted areas or step-down features are often used to increase the amount of paste available at the hole site. The components must be made of high-temperature plastics that can withstand the full reflow cycle without melting or deforming.
Careful calculation of the hole-to-pin ratio is necessary to allow the molten solder to flow easily into the gap through capillary action. This method is particularly effective for high-density boards where there is no space for the large keep-out areas required by wave soldering equipment.
Inspection Standard
Solder fill requirements for these joints are governed by industry standards like IPC-A-610, which typically mandates a minimum vertical fill percentage. X-ray or automatic optical inspection systems verify that the solder has completely wet the pin and the interior of the plated through-hole. Consistent thermal profiles are needed to ensure the metal reaches the center of the board.